Enerdrive 200Ah Off-Grid 4×4 Bundle with RCD & AC Transfer Switch Inverter

Enerdrive 200Ah Off-Grid 4×4 Bundle with RCD & AC Transfer Switch Inverter. The New Enerdrive Generation 2 (G2) B-TEC 200Ah Lithium Battery now comes with a 5 Year full replacement warranty. Pack includes: Enerdrive ePOWER B-TEC 200Ah Lithium Battery EPL-200BT-12V-G2 Enerdrive ePOWER 12V 40A DC to DC Battery Charger EN3DC40+ Choice between a 2000W Pure Sine Wave Inverter (EN1120S) or 2000W Pure Sine Wave Inverter with RCD & AC Transfer Switch (EN1120S-X) PLEASE NOTE: The bonus battery tray is currently on back order until early April. All orders will have the main products shipped and the battery tray will be shipped separately once back in stock. Enerdrive ePOWER B-TEC 200Ah Lithium Battery: Enerdrive have released the new ePOWER B-TEC 200Ah Lithium Battery with new features including: BMS restart button for easy recovery RS485 communications port for advanced system integration Raised terminals for 360 degree cable connections Re-designed battery case for easy serviceability Battery box and straps INCLUDED – nothing more to buy! The ePOWER B-TEC is designed and intended for use in deep cycle applications where a single battery is required that meets the amp hour capacity. Smart Phone Monitoring System The Enerdrive ePOWER B-TEC battery incorporates wireless Battery Monitoring Technology. By downloading the Android or Apple app to your smartphone or tablet device, you can monitor the following information; Battery Capacity Battery Voltage Battery Current (Amps) Battery State of Charge (SOC) Battery State of Health (SOH) Battery Status Individual Cell Voltage Battery Temperature Battery Cycles Battery Alarms Battery Event Information Battery Management System The battery is also equipped with an internal LiFePO4 Battery Management System (BMS) that can monitor and optimize each Prismatic cell within the battery during normal operation. It will protect the battery pack from over charge, over discharge, over temperature & short circuit. The BMS helps to ensure safe and accurate operation of the battery. Size & Weight Savings Lithium v AGM Capacities; 200Ah Lithium = 360Ah AGM (Based on standard depth of discharge for both Lithium (80%) and AGM (50%). The ePOWER B-TEC battery provides 60% more usable power than its equivalent lead acid cousin and being nearly 50% lighter and 30% smaller makes for a superior alternative. The ePOWER B-TEC battery is perfect for camper trailers, 4WD’s (AUX battery), caravans, small water craft, low power communication sites or any other application that requires the use of a single deep cycle battery that meets the amp hour capacity. With over 5 years of researching, designing and testing lithium batteries and the associated charging systems, Enerdrive are at the forefront of lithium battery systems in Australia. Enerdrive are the only Australian company that can supply a fully integrated self-branded energy system to suit your setup. With over 1200 complete systems in operation Australia wide, Enerdrive is regarded as the leader in the field of lithium batteries and energy systems for Mobile, Marine and Remote applications. Please Note: This ePOWER B-TEC lithium battery is capable to be paralleled to a second ePOWER B-TEC lithium battery. For maximum performance and lifespan of your lithium battery, no more than 2 batteries should be connected together to increase your overall capacity. Overall loads when paralleled should not exceed the current limits of a single batteries BMS. Enerdrive ePOWER 12V 40A DC to DC Battery Charger: Enerdrive ePOWER 12V 40A DC to DC Battery Charger designed to meet the rugged demands of Australian conditions and delivering multiple source charging for DC systems. The Enerdrive ePOWER DC2DC Battery Charger is a fully automatic multistage, multi input battery charger with the ability to charge from either an alternator linked to a battery; or via solar power with the in built Maximum Power Point Tracking (MPPT) Solar Controller. 12V 40A DC2DC Battery Charger Features Two totally independent DC Inputs for both engine and solar regulation charging one house battery bank output DC M6 screw terminals that will allow for large battery cable connection between all sources A dedicated Maximum Power Point (MPPT) solar regulator The same battery algorithms as included in our AC mains ePOWER battery charger including a specific lithium charging profile 40A output up to 40+°C with thermo controlled fan cooling Fully programmable LCD display to show which source is charging the battery along with charger status, voltage and amperage Temperature sensor included in charger for more accurate battery charging For In Vehicle & Marine Wiring Diagram, click below: For Towed Vehicle Wiring Diagram, click below: Enerdrive ePOWER 2000W Pure Sine Wave Inverter: Enerdrive ePOWER 2000W Pure Sine Wave Inverter state of the art, easy to use design, this 2000W inverter will offer you reliable service for providing AC power and 5V USB power for your home, boat, caravan, 4WD or commercial vehicle. The Enerdrive ePOWER 2000W Inverter can run many AC powered appliances when you need AC power anywhere. The 5V USB power can charge many USB powered devices. Features Australian GPO Outlets True sine wave output is ideal for operating motor loads, and to reduce stress on surge protection circuitry, meaning potentially longer equipment life Audio alarm with warning/error codes to alert user to check inverter condition before unit shutdown Automatic shutdown protects overload, over temperature and low/high battery conditions High surge capacity for products that require more power to start (2 x constant) High efficiency conversion of battery available power to AC power Mounting brackets for permanent installation Heavy duty DC battery stud connectors Includes 5V USB port 5 Year Warranty *Note: As stipulated by the manufacturer Enerdrive, failure to charge the Enerdrive Lithium Battery range with an Enerdrive or Redarc Lithium Profile battery charger will void Enerdrive manufacturer warranty. Enerdrive ePOWER 2000W Pure Sine Wave Inverter with RCD & AC Transfer Switch: The Enerdrive ePOWER 2000W 12V Pure Sine Wave state of the art, easy to use inverter will offer you reliable service for providing AC power for your home, boat, 4WD, truck or Caravan. The ePOWER 2000W Inverter incorporates a 16A AC Transfer Switch which allows for seamless AC power transfer between Mains/Generator and Inverter. This helps to keep your appliances running with almost no break time on AC transfer and allows for a much simpler installation on-board. This inverter is built to operate basic equipment such as power tools, computers, microwave ovens, televisions and other appliances that use up to 2000W of power for operation. Features: Seamless 16A AC Internal Transfer Switch AC RCD/Safety Switch with test button Removable LED Remote Control Display Panel Regulated Pure Sine Wave Output Silent Operation Compact Size for Easy Installation USB Port for charging USB devices PS6 Mode AC Transfer Cable 2 year warranty New PS Mode: ePOWER Enerdrive Inverters with AC Transfer Switch now include the new PS6 mode. AC Transfer Cable Now Included as Standard: Now included with all AC Transfer Switch. Inverters is a 4 metre AC lead with molded Male/Female IEC Plugs fitted. This allows the installer to cut the lead and hardwire the IEC plugs directly. This will speed up installation time and eliminate any connection issues within the plug.
Read more