Remote Air App

The controller and receiver motor have a built-in Bluetooth module. An iPhone i0S APP controls the lens, lens data, and set automated lens movements.

Handwheel Controller

The controller features a 75mm diameter large follow control handwheel, which is more effective when using the palm of your hand to pull focus, or when wearing gloves. With 1/4"-20 mounting holes, it can be easily attached to the included handle or mounted on virtually any handle, monitor, or arm.

Focus, Iris, Zoom

The handwheel incorporates a focus controller, a zoom rocker, and an iris rocker, allowing you to simultaneously control up to three axes, with the proper number of motors. The focus controller features a built-in LED light and glow-in-the-dark marking disks that allow you to see your custom markings while in low-light situations.

Battery Life

The controller uses a replaceable 600mAh battery, supports hot plug, and features a battery life of 12 hours.

Data Display

The controller and receiver motor both use the same data display mode, and the LED screens are placed so that the data can be easily read.

All-in-One Control Button

The Remote Air Pro 3 features an all-in-one multifunction button. It allows you to quickly set the signal channel, control channel, motor speed, and remote recording.

Remote Run/Stop

The handwheel controller is compatible with RED and ARRI as well as LANC control of your camera’s run/stop

Handwheel Handle

The Remote Air Pro 3 includes a redesigned handle from previous versions. You can now mount and unmount the handwheel from the handle. The handle incorporates nine 1/4"-20 mounting holes that allow you to mount accessories such as a mobile device, monitor, wireless receiver, and lanyard. The handle is made of high-strength aluminum alloy and durable rubber.

Wired or Wireless

If you want to operate the focus controller in wired mode, simply connect the 6-pin motor drive cable from the motor to the controller.

Motor Improvements

• The Remote Air motor is 0.67" thick, down from the previous generation’s 0.75"
• It also has twice the amount of torque of the previous motor
• The motor also has 8192 DPI (steps of resolution), which is significantly higher than the previous versions 1920 DPI, this provides the motor with increased accuracy
• The receiver motor’s OLED screen has been moved to the side for easier viewing. It can display the signal channel, signal strength, and the controller’s battery information

Motor Power

The new MOTOR AIR supports 7 to 20V input voltage, which means that it can now be used with a 7.2V power supply.

Calibration

You can calibrate your lens manually or automatically, adjust the lens spe

Motor Torque

SThe PD-RX REMOTE AIR Receiver Motor features 0.5 Nm of torque. The PDMOVIE MX Motor features 0.8 Nm of torque. The PDMOVIE Motor Pro (the slave motor) features 1.2 Nm of torque, useful with stiff zoom lenses.